R.L.S. 3D clips

  • In addition to level (“lippage” removal), the “3D” clip creates the joint (both with “+” and “T” layout) in both orthogonal sides of the tiles;
  • Thanks to the retractable “spacing fins”, the “3D” clip is suitable to be positioned both in the tiles intersections (both “+” and “T” layout) and on the tiles sides. So, when installing large format tiles, for which putting the clips just in the tiles intersections is not sufficient to ensure proper leveling (“lippage” removal), the “3D” clip can be used in both positions;
  • The “3D” clip accepts the same wedges and pliers of all other R.L.S. clips;
  • The “3D” clip is shipped in flat position so to reduce volumes by nearly 50% (in comparison with the standard R.L.S. clip);
  • Prior to use, with a simple and fast movement, put the “3D” clip bridge in vertical position;
  • Minimum joint size: 1,5 mm (1/16”). As required by UNI U87005510 regulation. Now also available for 3 mm (1/8”) joint;
  • Suitable for tiles thickness from 3 mm (1/8”) up to 12 mm (1/2”);
  • If used in the tile intersection the 3D clips reduce consumption by up to 76% (compared to classic clips usedon tile side only).



error: Content is protected !!