BC45 to perform 45° bevel cuts (“jolly”)

Angle grinder not included. It includes Ø 115 mm disc.

BC45 – DEVICE TO PERFORM 45° BEVEL CUT (“JOLLY”)

Art. 433BCOH (angle grinder not included)

• Device to perform 45° bevel cut high quality finishing (“jolly”) directly on construction site (actual miter angle: 47°)..
• It works leaning and sliding on the edge of the tile (or slab): this guarantees a fast and precise work execution and allows to work without any limit on length.
• The anti-scratch plastic slides ensure optimal smoothness on the slab/tile.
• Maximum slab/tile thickness: 16 mm (0.63”) with Ø115 mm (4 1/2”) blade; 20 mm (0.79”) with Ø125 mm (5”) blade.
• The two handles are designed to easily allow the necessary pressure during the entire length of the bevel cut (entrance, slab side, exit) to guarantee both optimal results and maximum ergonomics.
• Cutting depth adjustment: by adjusting the dedicated knobs, it is possible to determine the amount of material to be removed (farther or closer to tile glaze). Once the adjustment is set, it stays for any tiles/slabs thicknesses.
• Blade tilt adjustment: by acting onto dedicated screw, blade can be tilted to prevent its rear chipping the edge of tiles/slabs.
• Suitable with almost all angle grinders with power between 600-1100W.
• Available for grinders with M14 arbor attachment (art. 433BCOH EU) and for angle grinders with 5/8 ‘’ – 11 arbor attachment (art. 433BCOH US).
• Angle grinder not included.
• Dry use (standard version) or wet use (to perform wet cut in combination with Kit for wet cut and dust suppression – Art. 433PWW A, BC45 must be equipped with cordless/battery operated angle grinder or corded model having rating IP54* or any higher).
• It comes supplied with: Ø 115 (4 1/2”) “Cross-Turbo” blade, use and maintenance manual.

* Safety Regulations may vary from Country to Country. Therefore, it is strongly recommended to refer & comply to the legislation in force on the Country where the products is being used.

KIT FOR WET CUT AND DUST SUPPRESSION

Art. 433PWW A

• Wet cooling device to be used in combination with POWER RAIZOR and BC45.
• Blade cooling with water grants:
  1) Complete suppression of dust;
  2) Better cut finishing;
  3) Quicker cut.
• Both adjustments onto tap and onto spraying nozzle allow a perfect cooling with a minimal amount of water.
• To be used only in combination with cordless (battery operated) angle ginders and/or corded models having rating IP 54* or any higher.
• It can be used with any cutting position/angle (45°/90°/180°).
• Carrytank capacity of 8 litres (1,75 gal) with relief valve.

* Safety Regulations may vary from Country to Country. Therefore, it is strongly recommended to refer & comply to the legislation in force on the Country where the products is being used.